Where is everyone #5

Put about 20 miles in the trails today

And both feet are still intact Lol

 

I told the wife she should embrace her mistakes

SHE HUGGED ME!!!

 

Lmao
Well, you know how it goes. Start making that run for the home 20 & ain't nothing gonna stop the hammer of the ddec 2 11.1's!!

285 bypass around ATL, all lanes blocked.. Who was it again that said "Follow that Can!!" Lol



Manchester was locked up when I squeaked by..
Now the one sb i65 in Portland, TN I think it was..
The rest of the way, GA wim in the granny all say roll on. The sb FL Jasper was blocked off for construction. Sb Ocala was open, so I had to grab 19 & holler "45 across the wim" lol.. Was closing in on the 11hr mark on line 3 after the delay in ATL, & had to keep er rolling.. I did back off to ~68ish mph though.. Your right, screaming along at 1800 for hrs on end is a little rough on the old gal..

 

Trust in Baal Gates Lol/Not

 

Do you already have a magna grip tool?

 

Priced them out and they're not cheap. About $1700 new. There's a place nearby that rents them. Going to see what they rent out for or if they'll sell a used one.

 

I'm going to have to tear into some cab panels on my truck soon and have been shopping around. Wasn't sure on what brand to go with. Looks like the main 3 would be Huck (of course) 2025, Gage Bilt, or Reliable (chinese). Just didn't know if you had any experience with any of them. I got an estimate from Peterbilt, and even with my disdain for bodywork, it's tempting to just buy the tool and do it myself.

 

Yeah at $150/hr I'll be saving money after 12 hours of labour. The Reliable one is what I was looking at earlier.