Where is everyone #5

If it 'twas me, I'd have just got a new conmet hub rather than replace studs, but being the fine location you're doing repairs, I understand. Now the curious side of me has to know how long it's been since the wheels were touched? I've never had one get loose after the initial re-torque.

 

Ali Arc Industries – We are your upfront armour for your journey ahead.
The prices on the website are in Canadian dollars fob Winnipeg MB.
You should be able to order through your local Freightliner dealer.
You can also check truck wreckers in MI,WI and MN for a used one either Aliarc or Herd.

 

My BBQ is not sweet, But still brings all the boys to the Yard.

 

A place I used to work had a few trucks with those. Definitely a decent bumper. I wouldn't hesitate to run one if I had a reason to.

 

I can't say. Was it to the north?

 

To be quite honest, when he did the other work on that axle, I don't think the wheels even came off. Brother, if I was at a shop, I prolly would have just did the hub. However, being stuck on the side of the road 50miles from a shop....I didn't need any unforseen challenges. The ole...we need to go back to the shop for parts bit......doubling my bill.

 

I was a kid, I think so.

 

Understood, but those were over torqued.

 

@Lostkeys

The man to ask isn't here. But there was a lot next door. Cj Roger's, later Red Kap had to buy it, thier drivers were not allowed any place else on the AVE.

This is foggy at best. Dad was White Star and or Kaplan back then. Wyoming Lunch was thier office.

 

Agreed