I do have w wiring diagram of the truck breaker box and it shows a shutdown solenoid fed from the ign. switch ( hot in run) but ?????
Cat 3406 won't start
Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by BobHjr, Oct 10, 2021.
Page 2 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
It's a 1LW. No shut down solenoid. Do you get a check engine light when you turn the key switch on?
Roger McG, Slowpoke KW and Caterpillar Cowboy Thank this. -
Runs on either then dies I'm guessing electrical. Either engine electrical (sensors) or not getting correct power to the ECM. I've had both happen.
x2 or x3 I lost count your 1LW does NOT have a shut down solenoid. Your generic freightliner diagram may have that as an option but it's not on the 1LWRoger McG, BobHjr and Slowpoke KW Thank this. -
Pull the filter out of the davco and see if they left the old filters center rubber gasket on the stand pipe If they left the rubber seal/gasket from the old filter on the center standpipe it will do this.
-
-
No check engine light during the system check when you first turn the key on? Check ECM constant power, keyed power and ground.
-
-
I do know that there is a problem in the solenoid that mounts on the firewall ( looks like a Ford starter solenoid) as the owner has two of the terminals jumped.
Where is a good source for a diagram?Last edited: Oct 10, 2021
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 2