Yes, You need door part number- F31-1259-06
Entire dash must come out to replace the door. Also install a new actuator on the new door. I have the procedure if your gonna tackle yourself I can put it up. Big job. My guys in the shop take around 5-7 hrs depending on the tech and thats if they have already done one.
Vent control not working
Discussion in 'Ask An Owner Operator' started by Varinderkahlon, Oct 20, 2021.
Page 2 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Goodysnap Thanks this.
-
Here you go.
Lots of screws- Use a #2 square bit on the phillips screws- you''ll see what I mean here once you get rolling. Extra set of hands helps to get the dash in and out once its all loose.Attached Files:
Varinderkahlon Thanks this. -
-
-
-
I would, but if there is no damage to the splines you could reuse. Easy swap if it fails internally. If the splines are chewed it could wear on the new door.
Varinderkahlon Thanks this. -
-
Did you get it?
Remove the Mat from the bottom of the cup holder- 2 screws under the mat. This releases the bottom cover- Then access the shifter screws LH side to remove the cobra shifter and disconnect electrical.Varinderkahlon Thanks this. -
Attached Files:
-
-
Goodysnap and Varinderkahlon Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 4