2010 Maxxforce 13 exhaust manifold replacement

So you are working on a 2007 emissions model Maxxforce 13? I show the exhaust manifold bolted to the head with all bolts, not studs. The turbo mount is by studs, is that what you mean? There is no gasket between the turbo and exhaust manifold, just a flush mount.

 

Ok gotcha. Those EGR tubes are one time use. Replace the tube with a new one and new gaskets.

 

So unfortunately my 2011 Maxforce 13 exhaust manifold is leaking at both fey ring joints I replaced the fey rings on the rear joint and it still leaked and i also discovered that the front cup joint is leaking too so I plan on changing the entire manifold. What needs to be taken off in order to complete the task?

 

So unfortunately my 2011 Maxforce 13 exhaust manifold is leaking at both fey ring joints I replaced the fey rings on the rear joint and it still leaked and i also discovered that the front cup joint is leaking too so I plan on changing the entire manifold. What needs to be taken off in order to complete the task

 

How bad are they leaking? You’re allowed some leakage from the fey rings h til the manifold warms up, there’s also cuff seals that can be installed. They’re a pain to do when everything is on but possible.

 

hello Heavyd, did you ever come across a code 2247 on a epa 07 maxxforce 13?

 

Fuel aeration is the usual cause of this. What can happen is the plastic fuel lines become hard and brittle and can develop very small cracks, or where the fuel line connector body is fastened to the fuel line also starts to become brittle and allows air to get sucked in. A good sign of this is actually just a small film of fuel developing at the location of the leak. Check over all your fuel lines for this.

 

Great thanks, nobody seems to have seen this code in my area