Eaton 402 center sections

I have a set of eaton 402 axles with 3.90 ratio and budd wheel hubs.
All could be for sale but only really advertising the center sections because the housings are cracked around the spring perch area but everything else is in working order. The power divider was rebuilt in the recent past but I don’t know much about the rear rear. upgrading to Rockwell 46k axles with diff locks on a truck I am rebuilding and have no need for the eatons

 

Near Quincy Illinois
Thinking around 1200 for the pair of pigs or 600 for back and 900 for the front i know that will be the next question from someone lol.

 

Yes, I have done quite a few and Rockwells to the worst one I have ever seen was this Rockwell sqhd

 

The pictures hardly do it justice
That tube was really only connected across the bottom and about 1/2 way up the front. That was on a reyco 4 spring and really hadn’t wore down that bad just cracked all to pieces. We did replace that housing after asphalt season ended mostly due to concerns with miss alignment of the axle shaft and wearing the inside tire. All of the welding was still looking good.