Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 20192 of 21987
-
TX2Day, CAXPT, singlescrewshaker and 4 others Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
With a C15 twin setup could get interesting rapidlyTX2Day, CAXPT, singlescrewshaker and 3 others Thank this.
-
This A model had the same setup from factory. It was a Canadian spec truck…
TX2Day, CAXPT, singlescrewshaker and 7 others Thank this. -
When they called yesterday I voiced my opinion of setting it on its side, they don’t seem to care for that since it has to in a small door at receiver, and no way to upright off the trailer at that location…TX2Day, CAXPT, singlescrewshaker and 5 others Thank this. -
Is there some reason 12' high is a problem? That's an easy stretch RGN load. Would be about 13'8-14' high depending on how much the trailer squats. 45-46' in the well would make some turns interesting depending on where it has to go but not impossible by any means.
-
Bet it had a steel firewall in it too.
-
Getting it out the door is an issue, if they raise more than 12” off the floor it won’t go out the door…. -
I guess topping Fancy Gap at 41 mph ain’t bad for a dinosaur…..
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 20192 of 21987