Where is everyone #5

Yep, updraft. No idea what its off of though.

I did one last summer but there wasn't much tuning needed. That one just needed a new float needle and a cleaning. This one is a mess. Everything's plugged up and the throttle/choke shaft packings are shot. Even the brass float was a massive green blob.

 

Does it have an adjustment on the bottom of the bowl or just a drain plug…?

 

Just a drain plug. It cleaned up good in my tank but I'm going to have to attack this one with the wire wheel and a Dremel. Full of sand and some rust too so I'm guessing it sat for years with the inlet wide open.

 

Which one does it look most like… ?

 

Not often you see “Doc” from Gunsmoke in other roles….

 

I was too busy looking at the food to notice the table.

 

One and four are closests. The two needles on this one are in the top housing and are inline with the venturi.

 

My mother was a ER nurse with 3 boys. Counting Dad, 4 boys. We were still in the ER all the time. But what she saved the family in minior patch jobs was thousands of dollars.

 

Our Vet helped out a lot with the external things