Slightly Dent Sidewing On Truck??

Sometimes you can pull a dent out with a plunger.

If the supports are bent you might try loosing them up and try to bend it back.

I bet if you try you can make it better. If not in time you will get use to the dent.

 

it will depend on the dent location (on the edge of panel or in the middle etc), one option is to use a rubber hammer/mallet and a block of timber, im asumeing the panel is ally/alloy.

 

it happens to some of us... been driving truck for quite a few years... bent my first front bumper a few days ago.... Was really stupid. plenty of room just a big lack of attention.

 

Those flat panel air deflectors can't really be straightened very easily... they are usually replaced.

 

buddy just a week ago had one get bent on his pete by the crane hit it with a steel beam while unloading kw dealer estimate $2100.00 to replace

 

I banged one up on an FLD I used to drive... I came into the office with my tail between my legs and fess'd up to the boss... he laughed and told me to take it to the shop... seems they'd replaced about four just that week!

 

I tried to repair one...............................................

Don't.....................

 

The rear air deflector is aluminium, depending on the damage it is next to impossible to fix. One of our drivers dented one on our Century. I tried to straighten it out with no luck. Bought a new one for $275 and first trip he dented that one also however it's not as bad.