BXS conversion

Discussion in 'Trucks [ Eighteen Wheelers ]' started by dbtrucking, Nov 8, 2011.

  1. Nov 8, 2011 #1
    dbtrucking

    dbtrucking Bobtail Member

    6
    0
    Dec 19, 2010
    waseca,mn
    0
    I was wondering if the 2ws/1mm , 6NZ wiring was in the same pin locations, for the injector common wires and signal wires?
     
    Last edited: Nov 8, 2011
    dbtrucking, Nov 8, 2011
    dbtrucking, Nov 8, 2011
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Nov 10, 2011 #2
    Mr. Haney

    Mr. Haney Road Train Member

    2,693
    2,041
    Dec 17, 2008
    0
    yes, the 3406E, C-15 and C-16 engines have the same pin locations on the ECM
     
    Mr. Haney, Nov 10, 2011
    Mr. Haney, Nov 10, 2011
    #2
  4. Nov 11, 2011 #3
    dbtrucking

    dbtrucking Bobtail Member

    6
    0
    Dec 19, 2010
    waseca,mn
    0
    Thank you Mr. Haney. I have found an ECM, all I have is serial# and a part #, is there any way to verify the ECM without hooking it up to someones computer. I'm afraid if they see something in there they will want to update it, possible losing anything I may gain. They said it is a 600 hp ecm thats all I know right now.
     
    dbtrucking, Nov 11, 2011
    dbtrucking, Nov 11, 2011
    #3
  5. Nov 11, 2011 #4
    power freak

    power freak Light Load Member

    220
    60
    Apr 23, 2009
    0
    No the only accurately way to verify the current settings is by hooking it up to a Laptop or prolink to check the current settings. You can run the serial number and find out what the Hp setting was from the factory for the ECM but it very well may have been changed at dome point in time.
     
    power freak, Nov 11, 2011
    power freak, Nov 11, 2011
    #4
  7. Nov 12, 2011 #5
    dbtrucking

    dbtrucking Bobtail Member

    6
    0
    Dec 19, 2010
    waseca,mn
    0
    Thank you, that's what I was afraid of. All I have is the serial # of ECM, not the engine. Peterbilt said there was no way to look it up, but then again I have never had much luck with that shop to start with. The gentleman I talked to said it was 600 hp, 3406E, a 1MM, I'm guessing. I guess $100 to check it out might be money well spent. It has to be better than the OEM in here. Thanx again.
     
    dbtrucking, Nov 12, 2011
    dbtrucking, Nov 12, 2011
    #5
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.