Post your flatbed load pictures here

You hear those "truck drivers" that say they have 80 thousand on to do you!

 

I haul that same kind of sheet steel all the time. I usually have them butt the back stack against the front one. Mine are also a little longer so I have to put chains across them. Where did you bring those to?

 

Few loads of John Deere stuff from this past week.

 

to Dragon, in Los Fresnos, TX. Dragon makes those frac trailers they look like a container with a single axle on the back, and no landing gear so it looks likes its dragging down the road, and they usually have a bright yellow staircase going up one end





American Trucker

 

me too.... usually 45,500-46,000# and I just put the front stack with the rearward part at the middle of the trailer and the rear stack butted up against it. My truck weighs 22,000# and i have yet to be overweight on the drives. And I always use chains as I have seen too many of these loads shifted and slid forward on other trucks.

 

SHC You pick it up in Portage at the same place that I do.

I use chains and straps but I ALWAYS have X chains on the front ALWAYS!!! I have seen so many trucks that pick up at the same place on 80/94 with the load slid to the front of there trailer.

 

Hey your company called, they'd like to change you delivery address........To my shop.

 

HAHA!

For some its not all talk........

 

Except the ones that have 80k+ on the deck........aren't the ones on the radio talking about it. However with the right ECM tunes we are the ones passing you....up hill......without our flashers.

Hey Les, an ECM is the computer that controls the engine. Usually found on trucks built 30yrs after yours.

 

Uh huh I hear ya.....

Are you gonna work this week?

With all this warm rainy weather, I sunk in the driveway....