I'm getting an Occasional Buzz/Hum when i'm Keying up. What had happen was going down the pike a cardboard box flew up and took the antenna halfway out the stud. i screwed the antenna back in and every since then i hear this buzz while keying up. It goes in and out, if i was to grab the Mic cord it stops, so i change the CB Mic and it does the same thing!!
So do i have to get a new Stud and antenna?? or is my radio fried??
CB Buzzing/Humming When Keying Up
Discussion in 'CB Radio Forum' started by hawkjr, Jun 10, 2012.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I'd start with replacing the stud then check swr or vice versa
WA4GCH Thanks this. -
I'd say it is time to replace that particular antenna.the solder that connects the stud to the antenna internally is more than likely broken. I have had two francis,the 5.5' ones,break at the point you reference.one snapped and just swung down going down the road and the other hit a limb,or i hit the limb-whatever,and it separated like that,sliding up and down in the mounting end. Lots more ground noise became prevelant and was eliminated w/a new antenna,another francis.
-
rollingradios knows his stuff and should be listened to when he offers advice, but I'm going with x#1 on this one........especially if a Francis is involved! (I run Francis' too)x#1 Thanks this.
-
Francis antennas are just not what they used to be but I still will swear by them! and the bang for the buck just can't be topped-
-
I agree...and easy to find when you need to replace one.x#1 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.