L10 Cummins

Discussion in 'International Forum' started by CurtisLee, Dec 17, 2012.

  1. Dec 17, 2012 #1
    CurtisLee

    CurtisLee Bobtail Member

    8
    1
    Mar 16, 2012
    lynchburg tn
    0
    I have a 94 model ford aeromax with an L10 cummins in it. The truck will start right up no problem but the check engine light is on and engine fluids light is flashing and it will run for 30 seconds and shut off. It will start right back up but 30 seconds and it shuts off again. I'm assuming oil pressure sensor but where is it located? Any help is appreciated
     
    CurtisLee, Dec 17, 2012
    CurtisLee, Dec 17, 2012
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Dec 17, 2012 #2
    rank

    rank Road Train Member

    9,919
    113,510
    Feb 11, 2010
    50 miles north of Rochester, NY
    0
    Not sure about the L10 but I had the same problem with the M11 in my T800 three times. Once it was oil pressure sensor located just above the frame rail, on left side of engine block, near the front, below the AC bracket. Second time it happened it was the coolant level sensor located near the top of the coolant reservoir (which on my truck is on top of the rad). Third time the coolant was only actually down about an inch and the engine cut out when I went down hills. Make sure coolant level is topped right off
     
    rank, Dec 17, 2012
    rank, Dec 17, 2012
    #2
  4. Dec 18, 2012 #3
    jbatmick

    jbatmick Road Train Member

    2,200
    2,511
    Dec 1, 2009
    hastings, Fl
    0
    Coolant sensor gives more trouble than oil sensor. Check it first.
     
    jbatmick, Dec 18, 2012
    jbatmick, Dec 18, 2012
    #3
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.