Meltdown on the dyno...Help

Discussion in 'Trucks [ Eighteen Wheelers ]' started by Sumothertrucker, Jul 5, 2013.

Page 2 of 2
  1. Jul 5, 2013 #11
    blanco

    blanco Road Train Member

    1,221
    296
    Nov 20, 2009
    Gwinnett County, GA
    0
    in for drama...
     
    blanco, Jul 5, 2013
    blanco, Jul 5, 2013
    #11
    Heavyd Thanks this.
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Jul 6, 2013 #12
    Ezrider_48501

    Ezrider_48501 Road Train Member

    3,845
    5,134
    Apr 2, 2011
    bismarck, nd
    0
    i think best case your gonna get on this will be cat will pay for the 2 cyl your pay on top for the remaining. although most the labor should be covered in getting to the first two. i would certainly try to get them to do the whole works but i doubt it. best of luck to you
     
    Ezrider_48501, Jul 6, 2013
    Ezrider_48501, Jul 6, 2013
    #12
  4. Jul 6, 2013 #13
    Sumothertrucker

    Sumothertrucker Light Load Member

    92
    16
    Jan 10, 2011
    I c corn
    0
    It's an MBN motor with a 6NZ file. It only made 595hp at 1500rpm. It doesn't really start getting down until close to 1600.
     
    Sumothertrucker, Jul 6, 2013
    Sumothertrucker, Jul 6, 2013
    #13
  5. Jul 6, 2013 #14
    special k

    special k Light Load Member

    89
    38
    Sep 6, 2008
    Ontario Canada
    0
    I hate to say it but once they find out it's modded you'll be lucky to get what they offered. I'd tread very carefully and offer to pay a percentage of the remaining cost to do a complete inframe. It'll be all apart anyways so the cost might not be as bad as you think. Good luck
     
    special k, Jul 6, 2013
    special k, Jul 6, 2013
    #14
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

    • Page 2 of 2