Removing airline from dash valve

cut close with razor part of hose in valve no good anymore

 

There is a plastic retainer next to the fitting. Push in on the plastic and pull the air line out of the fitting.

 

GtownWing,if you can ,post a picture off the fittings.

 

Where the hose goes in to the gauge, there is a plastic or metal ring you can push in, push that ring in and pull on your hose, sometimes the ring is hard to push in, just make sure you push the ring straight in then your line will come out, but if you have a long enough of hose then you can cut it.

 

Follow the lines for a ways one could be an exhaust.

 

They're quick fittings. All you had to do was pump the air out with the pedal, push the little retainer in and out they come. They make them airlines in the dash short enough, good luck.

 

They are quick connects. Take a open end wrench of appropiate size that fits around hose and push down on quick connect while pulling out on hose. Easy sneazy. The valve should have had a couple of block off tabs in the box. If not any truck place should have them.

 

make sure all air is drained from system before trying to remove lines.PITA if you don't drain first!