transmission question( eaton fuller)

Discussion in 'Freightliner Forum' started by jbart318, Dec 13, 2013.

  1. jbart318

    jbart318 Bobtail Member

    2
    0
    Dec 13, 2013
    0
    Im new to this and hopefully i am specific enough with all the details and m using the correct forum.
    I have a frieghtliner truck/tandem axle/detroit diesel 12.7 liter
    Eaton Fuller trans rto1691ocas2 /serial # a1020638/rear configues rockwells(but not sure of the ratio)

    It wouldnt shift out of neutral,so the mechanics changed the x/y shifter, now have reverse and neutral,but no foward gears

    Any suggestions?

    Thanks in advance for any help in this matter
    Icc trucking
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Lucar

    Lucar Road Train Member

    1,396
    889
    Aug 22, 2012
    Texas
    0
    Time to change mechanic
     
  4. wore out

    wore out Numbered Classic

    14,322
    173,740
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    I'm sure he missed the slot or didn'y have it in neutral. And yes time to change if that baffles him
     
  5. jerry123

    jerry123 Light Load Member

    52
    24
    Feb 15, 2011
    Holland, Tx.
    0
    Several Independent issues can affect the transmission: air system contaminated, i.e. O-rings & seals at/around the range valve r contaminated by oil. Check the air filter regulator for funk inside the thimble sized metal filter. finding the problem move backwards and begin with cheap things: Not changing the air dryer cartridge when it should can increase oil...i.e. funk gets into the tranny. The air compressor, could be on the early stages of going bad..by increasing the oil pushed thru the air system. yet, still pumping air properly.

    Electrical: 6 gauge alternator wire running to the starter could have a break or strands of wire broken inside the insulated wire. (prefer 2 gauge wire) (the area of focus find wire broke or stressed: underside of motor at the two support brackets. The transmission wiring harness may need to be replaced. Electrical terminal connections to trannys computer +/- have been yearly cleaned. Battery terminal connections have been yearly cleaned.

    Sensors, may need to be replaced. ($25.00) there cheap. cheaper to instruct them to replace then diagnose & replace or misdiagnose and not replace...sensor is preforming in the iffy range, tested within perimeters.

    Older Truck problem solving: When making repairs, look at how long ago a part has been replaced. Do not replace a part because it was replaced AND it can go bad. (that is a verbal game). Replace, all parts of a node that have an Affect on the problem, (what if this part was bad) before doing a job the second time. Know the costs: parts and the area your working on, how long parts last, system parts that can have the same affect as the projected repair. By focusing on replacing those part, your truck will operate heavy mileage weeks without seldom a minor issue surfacing.

    Recall, wrecker bills are expensive and cost more then parts. Versus, Replacing parts in a node, is not unlike insurance, where your investing in your future trucks performance.
     
    Last edited: Jan 1, 2014
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.