I am replacing the two Thermostats and the two brass inner Thermostat Seals which are pressed into the Thermostat Housing on 2001 Volvo with a Cummins N14. Everything went well until I tried to install the new brass Thermostat Seals. It's a press fit and I can't
Install them evenly without it trying to come back out again or damaging them. Has anyone done this before or is their a special tool you need or a trick to press these in? Thanks.
Installing Brass Thermostat Seal in a Cummins N14
Discussion in 'Volvo Forum' started by boneebone, Jan 12, 2014.