Hello everyone as stated above, my Cascadia is not going into gear the fault code i'm getting is 27 and the gear display is blinking NF,Also my Heater blower motor is not turning off even with the ignition turned off any help would be appreciated. My truck has a detroit 60 series motor and a eaton fuller smartshift 13 speed transmission.
2009 Freightliner Cascadia will not go into gear Help
Discussion in 'Freightliner Forum' started by caspers88, Mar 2, 2016.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Where is the panel behind the driver seat?
-
Update on the situation transmission issue has been resolved but Heater Blower motor is still running even with the ignition off, Only way i can turn it off is i have to kill the master switch to turn it off
-
You can find fuse panel in most of them behind drivers seat inside plastic panel that runs up and down to rear of where door jam panel snaps in, you will find relays that can be wet from leaks above vents, seams from top roof panel can be calked up?
-
The TCM requires good clean battery power, check the wires connectors and fuse holders..
We have experienced this a couple of times, salt migrating into wire at terminal, turned the copper to mush..
... Philip -
What was the transmission issue
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.