Post flatbed load photos here V2.0

Oh and its gonna be a slow ### ride! My old girls got a abused old power plant that has a rough time pulling in the best of days... but pushing max leagal scale weight and 550 thousand on the od,..... im gonna put that old super 10 to the test..

 

Last night the sunset reflected off the truck, even through the dust and mud.

A light load of bottom tools. Made delivery today and the customer put three units on me to head back. Life is good.

 

A few of my most recent short moves.

A truck, forklift, and weld positioner to Michigan



58,000 Generator Rotor, 97,000 Gross



And finally, 3 water pumps to Minneapolis

 

Came across this on Facebook.

 

WTF?

 

Well go back to our trl this morning
Riggers say 20 mins. That was 8:30
Well at 10am they guide me into place
Oh the shackle pin is to big for the hole in the press. Ok lets just use 2 pieces of 2 in cold roll steel bars and place them into a 2 3/4inch hole
Then when they finally lift it, I noticed the trl is going to hit the one lift as the genius stopped me at an angle.
We got it, slow and easy and 2 backs up while the 87000 ld is hanging on those small pins.. Riggers R Us lol

 

Mine went easy as hell. Clock in at 5, leave at 545, drive a hour, wait 15 for my escort. Pull in at 7, unloaded and rolling before 8, back to shop for a 2nd load (same place) as it was pre loaded also i left the shop at 930ish, back out, 2nd drop at 1030, roll out at 11. Back to shop at 1145ish, load up a third run. This one is only 35 min out but has manual labor involved.... left the shop around 1230 droped and clocked out at 2... easy day

 

This looks a whole lot better then a hopper bottom behind my truck.

 

Yea but hopper no straps required lol

 

Only 12 straps and not alot of weight, plusses and minuses