ECM Series 60 Question

Discussion in 'Ask An Owner Operator' started by 9200 IH, Jul 5, 2018.

  1. 9200 IH

    9200 IH Bobtail Member

    35
    5
    Jul 26, 2014
    0
    Took my batteries out to clean and check water. Made myself a sketch of all the cable and wire hook ups. I forgot to mark down one wire. It is a white wire, it goes up into the harness and changes to 4 wires and then it goes into the top right hand connector of the ecm if you were looking at it head on. I am pretty sure is goes to negative but not sure. Did a bunch of searching online couldn't find anything to make me 100% sure.

    Any help would be great
    Thanks Mike
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. 9200 IH

    9200 IH Bobtail Member

    35
    5
    Jul 26, 2014
    0
    1996 Detroit Diesel Series 60 370/430 hp
    International 9200
     
  4. 77fib77

    77fib77 Road Train Member

    11,369
    74,047
    Jul 7, 2010
    St Louis
    0
    Picture of it?
     
  5. uncleal13

    uncleal13 Road Train Member

    3,797
    6,297
    Apr 9, 2009
    Humboldt, Sk
    0
    White tends to be ground (negative) in Freightliners. An ohm meter should confirm that it is grounded to the chassis.
     
  6. 9200 IH

    9200 IH Bobtail Member

    35
    5
    Jul 26, 2014
    0
    Thank you for your reply. My grounds are white too. The stuff I found online showed these 4 wires to be black on a Detroit diagram. I got it running. Everything is good.
    Thank you for your help
    Mike
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.