yes. tipical Euro to USA adapter.
Volvo used to sell it with 555 adapter. later I can post you photo
Chinese 9998555 adapter with vcads???
Discussion in 'Volvo Forum' started by bravoo67, May 1, 2012.
Page 8 of 9
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Hello, I apologize for resurrecting this thread but I have been reading a lot with no luck.
I am looking to buy a diagnostic tool that would work with Volvo D13, one has an eaton manual and the other is I-shift transmission.
would the 9995888 work to modify parameters?
Should I get the Nexiq instead?
would the nexiq work with the Vcads pro?
I have windows 7 home pemium in my laptop, jus usb ports. I could change if needed
I appreciate any help. -
I forgot to mention that both trucks are 2011 models
-
Tech Tool and VCADs give you limited access to parameters. For parameter change Dev2tool you need, but it is available not for dealers, but for Volvo developer engeneers
Newto Trucking and Mauricio.5283 Thank this. -
Thank you for the reply pablo, I will look into that, it seems like a very difficult software to get.
-
Chinise guys sell dev2tool)) LOL
-
Hello Pabo,
I purchased a set of Chinese made VCADS for my 2007-D16 and 2010-D13. It didn’t come with the 9 pin so I bought a cheap 9 pin-6 pin to OBD adaptor. I followed the instructions and installed it on my D630 laptop. The problem is when I hook it up it only scans to 10% and disappears and I get the message 56001 also no communication with vehicle. Please can you help me with any ideas on how to get it to work. The Chinese support service is not helpful. Below are pictures of my setup. Thanks a lot man!
-
-
-
loosing fuel pressure, check valves on fuel delivery, dont have d12 anymore but on drivers side of the engine there was 2 valves as far as I remember,
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 8 of 9