2014 cx7 loading

Are you loading with the belly dropped?

 

If your back bottom deck slides then slide it closer to the shotgun deck and keep the flippers a couple inches higher than where they are in the picture. I also keep the belly deck up a couple inches higher than the shotgun deck by lowering the front end of that deck. You could carry some 2x10”s about a foot long to ease with the transition if the back bottom deck doesn’t slide.

 

I have the very same training and have experienced the same problem. Finally figured out, raise your 17, 18, and 19 up virtually to the same level of your tandems and also flip forward the flippers over #20. I think you’ll be a whole lot happier!

 

Oh sorry, misunderstood. Raise 24 up a couple inches above where it would naturally lay. That solved my problem.

 

First I would try keeping the shotgun deck slid nearer to the belly deck, I leave only a couple inch gap between it and the belly deck. Raise the belly deck a couple inches higher than the shotgun deck, by lowering the other end.
If this doesn’t stop it then I would use 2X10”s. Place them at the edge of your shotgun deck with the flipper resting on them.

 

I'm not familiar with enough with the CX-7 to know how the belly is set up, but on the high rails, I always supported the belly with the shotgun. There was just too much deck behind that rear cylinder.