I previously posted about my bunk heater problem. But the video that was suggested, doesn’t address my problem. My heater works, to well, I start it and regardless of where I set the temperature, it just keeps getting hotter, till I have to shut it off. I need help with, is it the digi controller that is bad, or the ecm module, in the heater itself?
Espar bunk heater question
Discussion in 'Trucks [ Eighteen Wheelers ]' started by Lee Thompson, Oct 9, 2018.
Page 1 of 3
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
So are you saying it keeps blowing full blast even after reaching set temperature.?
Mine continues to blow but at a significantly reduced flow of air.
Sometimes I just have to shut it off.
Sometimes I crack both windows. -
What style of controller / thermostat do you have?
Lee Thompson Thanks this. -
-
-
just bought a truck with one, seemed to work good but quit, are you suppose to have it on with the truck running?
-
-
And when you turn it off you need to let burn off before you start your truck.
Takes 3 to 5 minutes , put your hand by the vent when it completely stops blowing you can start your truck.sealevel Thanks this. -
-
Your thermostat or sensor is in a position where it is too cold and gets no heat. Try moving it closer to where you usually are and see what happens.
uncleal13 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 3