Where is everyone #5

@ShooterK2 , stupid question here prolly, but have you had your driveshafts balanced lately?

Possibly a midship stub or tube outta spec? I always have the midship carrier section and slip shaft section to the front drive balanced as an assembly, and get the intermediate shaft(jackshaft) done at the same time.

 

No doubt. Been there, done that. It sucks!

 

Good deal... guess me and my bride gonna head to myrtle beach in the morning, this woman and the beach is mind boggling .

I run 77 north quite a bit and I agree it's miles of "barrels" lol.

 

On Flex air the ride height is measured from the front axle housing, AG400 is listed at 9"

Steve

 

Dentist and voting done. Guess I gota go back to work after 5 days off?

 

Rain is likely down here the next few days. There's a small informal car show at a burger joint called Burky's on Friday or Saturday evening. Out of season like now I think it's Saturday ?

 

Thank ya sir!

 

I believe the ride height for the AG 400 is 9". The difference from from the centerline of the wheel to the bottom of the frame is where your ride height would come from, and that should be 9" on your suspension.

Shooter did you have the AG 200 and then switched to the AG 400?

 

Got stopped by "the man" driver 1 dot 0. Details later.

 

Yes I did.