Where is everyone #5

If your married do not ever have your shop that close to house. It sounds good but its to close.

 

Couple used head bolts and some steel plate and a length of harden all thread

 

4.5 dozen. Well 4 dozen now hahaha.

 

I tried using a rubber coated hammer handle and a floor jack. Ended up just lifting the engine up.

 

@peterbilt_2005 @truckdad

Do either of you know where I am?

 

At the 100mm east, that was my old service area. Pulled a car out of the dinning area once. Had a tanker of chocolate rolled over in the front yard. Now funny fact. 1950's thru early to mid 1990's there was a service tunnel over to the Erie Island westbound. Drivers used to use it to trade toll tickets and get off one exit from where the ticket showed you getting on. Prior to camera days!

 

Yea you may even lift it if it was in truck. Thats why you need to make a puller. Just google liner puller and get to building. 1/2 impact will do it.

 

Getting closer. At @Zeviander's suggestion I'm going to keep it white. There is going to be some black and some shine in the mix as well.

 

Found on google. It will work. just makesure your lower part don't catch the block. Might have to spend some time getting it to fit. But it will work.

 

Right next to a white Cascadia pulling a dry van?