I don't believe we can write off tools as employees. I could look into seeing if I could rent or borrow the tool though.
Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 3818 of 21996
-
BigBob410, Slowpoke KW, PoleCrusher and 11 others Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Ok
here are a couple ideas
First off I would use plywood shins or folded mud flaps under the rear legs. Use a small sledge hammer to beat them under or use your winch bar to pry the legs up. You are trying to get the rocking to stop.
1 run a chain along the rail around 2 sets of stake pockets and then hook to the chain. Do this right at the rear legs. Thus will eliminate the back angle you have on pulling to the beam.
2 alternately if you can cross chain through the rear 45 degree braces on the back and pull down to the deck. Use some cut up strap as softeners if you are worried about the paint
3 anchor the strap to the rubrail but as close to the stake pockets or chain loops
The piece won’t likely weigh enough to get you into to much trouble for the remainder of the trip.
Good luckBigBob410, Slowpoke KW, PoleCrusher and 13 others Thank this. -
I plan on it, I dont have to pay for the straps but I've got to get quite a few more so I think the office isn't going to be too happy when I tell them I need 10 new straps so i can replace my broken ones and have spares, plus the edge protectors I've lost from these straps breaking.BigBob410, Slowpoke KW, PoleCrusher and 7 others Thank this.
-
@Lysdexis im up in the mountians so pictures took a min. to load.
you have the circle aluminum connections between pockets. that strong.
I dont listen to the "Company People any more"
Listen to us, as you will see you wont have broken hooks or ripped straps. We have been there and done that.
well looks like i need to grap some dogs and get them outside. ill check back in a bit.
05 out on the side.BigBob410, Slowpoke KW, PoleCrusher and 10 others Thank this. -
You should be able to write them off on taxes, anything that you have to buy for work you can, when I was a mechanic I could write off tools and clothes so you should be able to.
The strap breaking saga began when I put folded up pieces of strap under the rear legs to make it more stationary and all the feet touch the deck.Slowpoke KW, PoleCrusher, ShooterK2 and 8 others Thank this. -
What cant write off tools as a employee. Dont ever say that in front of my accountant. I was a wrench long before driver. I saved recipts for books, tools, batteries, boots. You can write of everything you need for work unless the employer provides it. And no personal vehicle milage. Now with that said. I have dont know what 2019 will bring under the Butt Trump tax plan.Slowpoke KW, PoleCrusher, ShooterK2 and 4 others Thank this. -
One of the best presents an outlaw will ever get. A life time of memoriesAl. Roper, BigBob410, Slowpoke KW and 27 others Thank this. -
I'm up in Canada though.BigBob410, Slowpoke KW, PoleCrusher and 10 others Thank this.
-
I will say this and close my mouth. You just said you had a concern with your side rail. I hate hooking them there. If you are not certain in your equipment error on the safe side.
Slowpoke KW, PoleCrusher, ShooterK2 and 6 others Thank this. -
Ok use a junk strap to protect the paint
and low cross with chainSlowpoke KW, PoleCrusher, ShooterK2 and 4 others Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 3818 of 21996