Where is everyone #5

You mean those pentagonal shaped ones that slipped over the section below?

Even erecting them was scary
They used to grease the lower section, then get the upper section started, then want you to just drop it.

 

Hah! Yes I do.

 

Well the Cops are finally going after speeders on I-5 / 99 /152



So be warned don't drive above 57 mph. They busted a fellow driver for 57 mph two days ago. Still curious on the fine amount.

 

You were lucky, remember party lines?

 

667 miles, Minot to Williston, unload, Williston to Rocanville through North Portal, reload, back to yard. 10 minutes to spare on 16 hour window. Whew.

Time to get sideways and wait for my load for Moorhead to get in tomorrow morning. Might be reloading Alden or Waterloo, not sure at this point. Either means back Saturday unfortunately. But at least I'm going somewhere new AND it's not going to be minus ####ing a billion for once!

 

Careful. Let's not overwhelm the youngin' with too many Ancient Technologies in one day now. Either gearshifters or Walkin' Around Tape Playin' machines. Both might cause a short circuit.

 

So you can handle the gearshifter AND the Walkman simultaneously ?
You're sure ?

 

Grandmother had the party line for as long as I could remember .

 

Well has his gaming system, but does he know about Atari, or Colecovision.

 

It’s a dual edge straight and serrator, it has two locks. They are made from a good steel so they hold their edge well, but it is a bigger knife. The Allen set screws backed out of the clips as you can see on the one I carried. Overall, I think with LEO discount it was about $55 so not too high.

I still carry the black one in the truck every day just in case I need it.