sq100 rear ends

those 40's are tuff i see guys haling 130,000 0n them all the time but they have easier run's than me less mountains less off-road than what i do ..........as long as temps are good no slack in the yokes just run her ..........they arent to expenseive at all if you decide to pull them i think a bearing kit is around 500 each or so (ballpark) may have to replace axle gears, cross, if you have alot of wear ...........they should last well over a million mile unless you get in a bind somewhere lol

 

Keep in mind, these are from the days when a 400 was a big motor. I ran SQHD's for a long time with a pretty hot motor and the only problems were the power divider. I did blow the front one up pretty bad once but that was due to a nut backing off inside in the power divider. My uncle ran pretty much the same setup as me and he was pulling his apart every 6-8 months. His driving style was hammer down and hard on the brakes. I never tromped down hard unless I was already rolling. He would always beat me from a dead start but I could catch him on the hills. We used to have a lot of fun truckin'

 

I have a complete set SQ 100 3:55 's ,Pete airleaf hsg spring hangers wishbones and drive line came out of a 1988 Pete 379 price resonable .

 

I am in need of a good uncracked airleaf housing front one or price for all you have. Please PM me I dont have enough posts to pm you.

 

Chad I sent you a pm let me know if you do not get it Tony

 

No PM I guess. email me zooktrucking@gmail.com