Yes released.
Ok the inward movement had me confused. I was assuming that it wouldnt move freely
I'll get ahold of it in a little bit and see if I cant get it to work past the spot that its stopping. The leading edge opposite the s cam does touch but the majority of the shoe does not when it stops turning. So it's likely the adjusters binding.
Ive done a few hard brakes to see of I can get them to click past on their own and self adjust but havent stopped to check them yet.
Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 12024 of 20342
-
Tall Mike, singlescrewshaker, Slowpoke KW and 4 others Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Loosen up the adjuster and check the cam bushings.Tall Mike, singlescrewshaker, Slowpoke KW and 5 others Thank this. -
@OLDSKOOLERnWV
New one for you. Just got a email from shipper that moving forward If a driver can not speak fluent English with crane operator. You will asked to leave mill property.
Just never seen it put out formally like that. I'll have to ask in the AM when I show up.Tall Mike, Lostkeys, singlescrewshaker and 7 others Thank this. -
Czar_Zero, MACK E-6, singlescrewshaker and 7 others Thank this.
-
I backed it off in hopes that if if does break free itll not stick its self back into place where it was. Evidence of a substance from between the backing and the friction material suggest it broke loose and adjusted to touch and seized up again to a dragging position and got hot and has possibly cooked whatever epoxy/adhesive/whatever was between the two surfaces.Tall Mike, singlescrewshaker, Slowpoke KW and 2 others Thank this. -
Just got back from dealing with @OLDSKOOLERnWV he talked me in ta buying this fine jewel off of him. Thanks Jim
Czar_Zero, MACK E-6, singlescrewshaker and 9 others Thank this. -
Last edited: Jan 5, 2020
Tall Mike, singlescrewshaker, Slowpoke KW and 5 others Thank this. -
And yes lifting it when backing off. Leaving it down to tighten till it stops then back 1/4 turnTall Mike, singlescrewshaker, Slowpoke KW and 4 others Thank this. -
Tall Mike, singlescrewshaker, Slowpoke KW and 6 others Thank this.
-
Tall Mike, singlescrewshaker, Slowpoke KW and 7 others Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 12024 of 20342