Caterpillar Engine Serial Lookup

Some dealers will some dealers wont. If its off warranty it aint no skin off their back.

 

How’s it going people? I’m new to this never posted.I have a 1995 Peterbilt with a 3406e cat 5ek17859 What hp rating and info on this? Any info would be greatly appreciated. God Bless.

 

Serial Number: 5EK17859
Sales Model: 3406
Built: 1994-06-02
Plant: 40
Test Date: 1994-06-02
Shipped: 1994-06-13
Tested: BB
Test Number: 01
Cell Number: 02
Engine Test Cell Results
Description Reset Test Results Specification Values
Specification Number 2T-5758 2T-5758
Arrangement Number 110-9656 110-9656
Corr FL Power R 435 HP 435 HP
Speed 1800 RPM 1800 RPM
COR FL F RAT R 20.5 GAL/HR 20.2 GAL/HR
CSFC 0.333 LB/HP-HR 0.330 LB/HP-HR
Adj Boost 26.2 PSI 25.7 PSI
Fuel Pressure 67 PSI 67 PSI
Oil Pressure 59.6 PSI 63.4 PSI
TQ Cor F RAT R 17.3 GAL/HR 17.5 GAL/HR
TQ CK CSFC 0.324 LB/HP-HR 0.319 LB/HP-HR
TQ CK Adj Bst 21.4 PSI 20.8 PSI
Torq CK Speed 1201 RPM 1200 RPM
TQ CK Tor TQ R 1650 LB/FT 1650 LB/FT
LI Speed 601 RPM 600 RPM
LI Oil Press 25.5 PSI 50.8 PSI
Hi Speed 1818 RPM 1820 RPM
Response Time 3.9 SEC 3.9 SEC
FL ST F SET R 0.341 IN 0.345 IN
FT ST F SET R 0.335 IN 0.337 IN
Timing BTDC 0 DEG 0 DEG
FLS(Intercept) 7 7
FTS(Slope) -8 -8

 

Thanks really appreciate it. Could this motor be turned up safely.

 

I can't idle up my mxs up past 750rpm. Is that an ecm setting?

 

Where is a good an cheap rear end shop around central Ohio? I'm wanting to put different gears in my rear end! Should I change the gears in my rear end or change the tranny?

 

What are your current gears and which transmission?? Do you wanna go lower (faster) or higher (slower). Can you change tire size instead??

 

Hi guys can I get info on 2WS16685 please. I’m in Australia if that makes any difference?

 

THE TRANSMISSION IS A 10 SPD. FULLER RTX-14710C (I KNOW NOTHING ABOUT THIS TRANSMISSION, IF ANYONE CAN GIVE ME SOME SPECS./INFO., THAT'D BE GREAT)!
REAR END GEAR RATIO IS, 3.91
TIRE SIZE IS, 295/75/R22.5
Now, it seems to me, that I need to go lower (faster)! It tops out at 72mph! That's my cruzin speed normally! I want an 85 mph truck, but also dont want a sled going up hills!

 

Thats an over drive trans, .73:1 top gear so switching to a 13/18 speed wont change overall speed. If you can go to tall 24.5 tires you can gain quite a bit of speed back but you loose power for the hills. Only way to have both speed and power to turn hills flat is ether pull light loads or have huge power under the hood.