I have kw t680 2015 paccar auto transmission. Sometimes when I change my shift from N to D , it doesn’t go nowhere. There is a light call ‘service’ beside the shift , puff up. And odometer (dash) where show shift number, say F. Then I turns of engine wait for 5 minutes, and it get back normal. Anyone can tell what’s wrong?
Kenworth auto transmission problem
Discussion in 'Kenworth Forum' started by KY15, Jan 28, 2020.
Page 1 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
-
The link below should help you with this issue. It could be a faulty shift sensor . Hope this helps.
https://faculty.mccneb.edu/dgilliland/DESL2120/rrUS110831trts0930.pdf
K.C Chiefs born and raised!!!Vampire Thanks this. -
-
I have the same problem with my 2017 kenworth T680 cummins ISX15 with Eaton Fuller transmission this is driving me insane someone please help me with these. My dashboard says transmission fault code and the service light next to the shifter flashes and then it does not let me shift into gear I turn it off leave it off for 2 to 3 minutes and then when I turn it on not only does it shift without a problem like nothing happen but the fault code is gone from the dashboard what is going on here.
-
Anyone that resolved this issue please share some knowledge with me.
-
-
-
Ta/petro can plug in (fee) and pull all active and inactive codes
johan52085 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 4