that one k a tec will hold as much yards as both of those Deeres and be moving dirt years after the Deere pans are toast. I will say 2 good...
you do realize your loosing alot of low end startability especially in reverse going from say 4.11 to 3.36 they I shift and M drive are...
just wondering how 3.36 gears could possibly be a good set up for b trains in a country where the speed limit is 60mph no matter how much power...
ground bearing is light years ahead of a mechanical in my way of thinking but you a are limited in ground clearance ( you can only shim a neck so...
there built down at Katy I talked to the owner a few years ago I did not know they was building a ground bearing neck. they are suppose to be a...
I think they go back before the 50' I seen one that used a cable instead of hydralics to take the neck off you had to have like a tulsa 64...
Dynaweld has had quite a history past decade Pitts owned them for some time and copied them now Dorsey owns them but now Dorsey owns them...
mechanical necks just seem to work best if you got a run from the factory to a dealership hard surface is kinda a must have for several reasons....
I don't know of any detach that like to work on uneven ground non ground bearing would be the most forgiving
had one of keens old talbert drop sides with one it runs the neck as fast has a wet line or gas motor there are larger than what you have there...
turbo and egr valve that series belt tensioners and fuel lines where also a problem they are a million mile motor dumb stuff usually gets...
if you bleeding all the way up to 2.4ghz and beyond you have a problem
also look at pitts its about the same money decent trailer for what your paying and you get a 5 position neck instead of 3 like Kaufman my 51ft...
been at it since the early 70's not lost 1 you do realize that new semi s are transported foward and backwards with uncovered stacks
never lost a turbo due to hauling equipment with a stack uncovered
intresting that they are running pete's the stores up in Mo. and Ar. they have new Cat trucks
that make shift to short fresh pile of dirt loading dock didn't help the man that trailer may had issues before he loaded the scraper defenatly...
around here people move 57k loads on 35ton fixed necks on a regular bases 64k is another thing
detach works but a good steel step deck or fixed neck lowboy should haul that no problems I'm alittle confused why he started shelling alum. out
actually a 10c is 13.xx to 1 low hole its between a 18 and 13spd if I was spending the cash for ratio change 3.90 min 4.10 or 4.33 are more...
