The rule of thumb is to add 1.5~2 ounces of oil for every component replaced. So if the compressor has oil in it already and you do a flush you...
One thing to look at on tires is whether or not they are worn flat accross the tire face. If the tire gets worn to a slanted angle accross the...
I used a set of PIAA's on my Star that were 135 watts per side. Had them down low like 14 inches off the ground. They worked amazingly well in bad...
Ok here goes.... the air-tek axle has some funky points to keep in mind. The ride height is absolutely critical. Too high or low and the toe goes...
That will work but they left out the inner ferrule that goes inside of the airline. Often times when you have a line leak like you dascribe with...
If you can check the amp draw with a digital multimeter it needs to be below 50milliamps dram with the dome lights off and everything off. Ideally...
Does this truck have the hendrickson air-tek steer axle? That is the air ride axle. This is a really important question....
Most of them have a 13mm headed bolt through a clamp that holds the sensor in. Usually you have to melt them out with a torch because they are...
The MBE vibrates and I think (my opinion only) that this leads to the pilot bearing coming apart. And it a problem more on the autoshift 2 pedal...
Lucky you. That style of sensor splits the feed for one to the ECM and one side to the truck speedo.
Thats the test. If the diameter of the cirlce on the card is greater than 2 inches then its time for a new compressor. Or if you have oil dripping...
The cab and its parts will be a nightmare just like a sterling
Get the antisiphon device the goes into the tank. Most of the locking fuel caps can be removed with a large channelock in about 5 seconds. Did...
truck parts places have them. So any dealer or independent will have them or some battery specialty stores even PS any dealer not just KW will...
Most trucks are wired the same so here goes..... The horn should be hot all the time. The horn button provides the ground when you push it in. So...
I have 2 dir grinders from home depot. A straight and a right angle. 25~30 bucks each I think, I have used abused neglected and beat them both up....
One thing to watch for is if you screw the stop bolt in to far it will make contact with the back of the hub or wheel seal. That stop bolt will...
BTW if its a 2 wire then everything reads from that one. If you have 2 sensors then the speedo reads from and the ECM reads from the other. The...
There is also a brand called Fatmat. Similar to to dynamat but not supposed to stink. Never used it. www.fatmat.com/
The speed sensor will be on the back reading the output shaft. It will be right behind the driveshaft yoke. The switches on top of the trans are...
