The wiring should already be there. Pop the dash panel and you should see a couple of plugs just hanging loose. They will have a white sticker...
You can also look up the code with Tech Tool.
The waterpump is possible, but not likely. It's not the EGR cooler. There's no oil flowing through the cooler. Only coolant and exhaust. Probably...
Straightening the steering wheel can be done during the alignment, but you are correct, it will affect the traction control. The steering angle...
There is a tool to hold all the rocker arms in place and remove the rocker shaft as one unit. Is it absolutely necessary? Probably not, but it's...
Just wait long enough and it will stop working on it's own. LOL I lost count of how many speakers I've replaced. There is no flasher. The flash is...
There is no flasher on a 2011. It's built into the light control module. The click you hear is a fake click coming from a speaker behind the...
I found it very common on the D13 for the intake manifold bolts to break. It blows the o-ring seal out and you lose boost between the intake and...
If you have the Davco primary fuel filter with the see-thru canister, it comes two ways. With a fuel heater and without. If you have two fuel...
There is a pipe flange on the back side of the waterpump that you can't see with the compressor mounted. If it's not leaking from the waterpump...
The cables are loose and arcing. Every time it happens, it chars the post and cable end weakening the contact. I had to do 20 of them on our fleet...
No. They're special bolts with a built in tension spring and washer. The washer on the original design bolt wears out and wears into the composite...
What year? Do you have a battery disconnect switch? If so, check the cables on the back for loose or scorched.
Drain the air tanks and look for coolant. Also check the purge valve on the air dryer for traces of coolant. Could be air compressor head gasket....
If you could fabricate mounts and hoses, lengthen/shorten driveshaft, fabricate a shift stick, does the 13 speed bell housing allow for a...
Pass-thru valve: on the firewall next to the steering shaft. Junction point for all the air hoses and harnesses going into the cab. Two smaller...
Alternator output is good. Probably need to clean cables and grounds on starter and pass-thru valve.
Are you going by the dash gauge? Do you have a hand held multi-meter? Before condemning the alternator, check the output voltage at the alternator...
Dirt and debris that collects around the stator is knocked loose and keeps it from spinning freely. Nothing to worry about on it's own. Only if...
Do you have a battery disconnect switch above the batteries? All 20 of our 2013's had loose cables on the disconnect switch. The high resistance...
