On trucks with the ADIS air dryer it will fill whichever tank has the most pressure in it first, then bring the other tank up after.
Sounds like you have a true low hp engine, not much you can do safely without really tearing them down and rebuilding with parts from a 550hp...
5EK96930 comes back as a factory 475hp engine, which can go to 550hp no problem. If it the valve cover would match the engine though, a factory...
No, those sensors wouldn't have anything to do with that. Those issues you mention are common if the output yolk on the trans is loose which could...
It might, It really depends on how the adaptor for the scan tool you bought is setup to work. (knock of com 3 adaptor?) Best bet is to see if...
You could have one of the engine speed sensors dropping out (crank or cam), it will run fine just reading the one engine speed sensor, you...
The one on the right is the offroad connector( proprietary cat data link), pin assignments are different than the truck j1939 standard(that's why...
I don't have a config file from a SDP to verify, but it does look like the SDP ECM has a outside air temp sensor, and calculates oil temp. so the...
DS404 and DSP40 are interchangeable. Some housings had 4 long bolts, 2 on the top, and 2 on the bottom, other housings had all short bolts. so...
Had quite a few issues inside those headlight housings. the chassis node that runs all the lights will either be mounted from the top of the frame...
Went through our local dealer, We told them what we wanted and all the axle info and they took care of the rest for us. Back when we did it we had...
I think every manufacturer is different but I know when we put a 20k front axle and lift on a Kenworth we built into a heavy haul truck we were...
I'm showing engine build date of April 2002, 395 or 410hp, 1450ftlb and sent to freightliner. A 2003 truck could have a 2KS or a MBL C12 in it,...
just spent some time on Cat SIS and this is all I could really come up with for published info from them on the topic. Cat doesn't list a minimum...
There service brake switch for the ECM will show 5v or less with the key switch on. Service brake switch for the brake lights should have 12v all...
For that truck you would just get the OEM gauge, install it in the dash, plug it in and then have someone that has Paccar ESA software turn on the...
Should be 3/8-16 threads, I usually use something like a 2 1/2in long bolt.
550 BXS typically only hit the mid 40's psi at sea level with the wastegate working properly, much more than that and its not uncommon to see...
If there are no codes and it just flashes the gear icon, it usually means it's waiting for the input shaft speed to slow down enough before it...
Unless someone has updated the flywheel to the 10inch center bore it will be a 8.5in center bore flywheel. The 8.5in center bore clutch I usually...
