Just wanted to add something here about Cummins that may help, Locate the EGR sensing tubes/lines, remove them and clean them out, this can be...
Anyone having issues with Connection? Freezing up? Not responding? Have re-loaded this software at the shop atleast 10 times now "lost count"...
http://youtu.be/BOmrvdbHULY This video is not the truck in question, however it is the same year, type and is doing the exact same thing as the...
Heavyd, for some reason logic builder didn't show the thermistor on the high side, replaced them all since there was an updated thermistor from...
Thank you, Truck has flashing engine brake light on cluster, ABS Truck and Trailer light ON, TCS, Check engine light, only one fault for ABS...
Where the heck does International hide these things? Anyone change one before? Bendix RC-60 ABS Module
Truck has come to me after dealership fail. No a/c complaint, all new parts from International, customer p.o.'d big time. What the?.... evacuated...
Found interior ground for trailer cord not properly grounding, by-passed ground circuit to new ground on frame, also noticed auxilliary circuit...
Ive seen this issue before, it is usually a faulty clutch pedal switch or brake pedal switch, (2 wire switches with 2-1/2 inch spring lever...
Found broken "looks cut" wire #567-c under fuse panel, repaired wire and found the relay it was going to was bad, replaced relay and now circuit...
After replacing some questionable wire connectors in the EECU harness at firewall I decided to disable some multiplexing functions in the EECU...
You can get the codes from the dash diagnostics using the control lever on right side of steering column. Find the fault you want the code for...
Can't read codes from cluster except "engine" ecu, all else dead, fuel pedal not responding at all, but 1937 is ok. Yes : Swapped engine ECM, and...
Just popping in to pass tme, I have no clue what the code is for and im too lazy to look it up at the moment haha, just thought I would say I've...
Been there done that, its actually the first thing I did. The strange thing is the CAN is perfectly fine, 60 Ohm, no shorts, power supply...
After consulting with Cummins and Volvo over phone, it looks like there will be a new cab harness ordered soon, however this harness can only be...
yikes, i see why you recommend cutting can out, however I have new information, the multiplexing codes go INACTIVE every 30 seconds and only stay...
Will test this tonight, also replacing ECM with brand new test ECM. The TPS tested good, is the ABS/EBS Module grounded to frame? FCMC connector?...
New resistors did not fix, still no communication with vecu, light ecu, brake ecu, srs ecu. I am at my wits end with this issue, any suggestions?...
Ordered new terminating resistors today, *cross fingers*
