I had a similar problem that went away after I replaced the foot valve and adjusted the free play and micro switch on the brake pedal. I drove...
Do you know how to adjust micro switch without the special tools? I want to make sure that is good.
There is no any faults. Active or inactive. I have PTT. Another symptom I have now is that I have no response to gas pedal, I have to come to full...
Hello I have a 2014 d13 with I shift and 560k on it. When driving in traffic seems like the clutch is not disengaging and I have to put it in...
If you have national seats follow this link HP Drivers Swivel | National Seating
I'm surprised that the top came off and I know that the pressure is applied under the top cap to retract/lower the cylinder which makes no sense,...
Hello everyone. I have question if any one seen the top of the double piston just come off. I was raising the deck on mine truck with small SUV...
I had a problem that I thought the truck didn't have power in low RPMs and was developing vibration and the only solution was to downshift...
I have 2014 vnl stinger with cx7 trailer, d13 and i shift, Mine Average stays over 6mpg running fully loaded mostly I95 anywhere from MA to FL....
WURTH HHS 2000 High pressure resistant, sticky lubricant This is very good lubricant for like door hinges because it goes spays as liquid but it...
I used gates tensioners, rollers and belts on mine old 05 vnl with d12( installed all at same time) and i didn't have any problems for 400k miles...
Unplug ECU and see if you got oil in it. Very simple job and you would eliminate one thing.
Did any one inspected for leaking injector hares and going into ECU?
I had one leaking on mine 2005 vnl. I looped the coolant line on the truck and left the plugs on the Davco open, after couple hours i had a diesel...
Does the Davco has 2 coolant lines going on the bottom?
Fuel filter and oil filters are very thin and they flex. I try to grab the fuel filter as close to the flange ### possible and its its tight but...
We didn’t do in any sequence and we were only cracking the bolts loose so all engine mounts had no tension. Then we used to re torque the bolts....
I know it might sound stupid but i used to work on cars for 13 years and we had some vibration problems due to motor/ transmission mounts not...
One more question. On 2014 VNL can you get the dog house out with out taking the bracket on top of the dog house?
I managed to replace both off them in about 8 hours. I think it would take me much less on regular truck. I have car hauler and the head rack...