Triple k heavy under lift.45000 lb lift rating retracted,32000 lb extended.has short,med,tall forks,receivers,wheel lift bars,straps,grade 100...
Mine did that too,I think it was from the bottom row of hucks.I suppose would have to cut the hucks and reseal between the skin then rehuck,but I...
Also if you have bad cables,or connections,they will usually be indicated by heat,especially with higher amp loads ie starting.take of batt cover...
I've seen that on a few n 14 engines.the older STC engines woulud smoke real bad when started when they break off too.
I agree with you heavyd,just haven't personally seen them fail.I've had the lock tabs broken before though.usually see code for weak...
I have never had the pass thru cause problems,but certainly worth a look.it has always been injectors with ours.with the intermittent ones it is...
Without a pin remover press,I'd say you may have to heat it if the pin is that tight.just using the jack from the floor limits your pressing power...
With stubborn bushings I've sometimes had to carefully use a hack saw to slit em to get em to pull out.otherwise air hammer but gotta be very...
Should be on the bottom of the decals of valve cover.Think it usually starts with an L and then 5 or 6 digits.
I know some of the late 90's or early 2000's had something like 5/8 tubes feeding the bags,instead of the 3/8 of the earlier ones.I know a few...
Also had one where the leveling valve was inconsistently not holding level and would cause intermittent shaking but usually did it on decel.this...
It's tough to say wo experiencing the shake firsthand,but usually I see prob in the frtend.does the wheel shake in your hands or does it seem...
The 100 steel brackets would develop cracks at the bottom where the bolt passes thru frt to back.the 200 alum brackets seemed to last the best.the...
Don't know about everyone but I'm in mn.
Hmm,I never have touched and looked to see if a difference,but if it is high reading,all the normal stuff.are you sure ant is good?I have seen the...
Been awhile since I had an n14 apart.pulley is timed a,b,c,for valve and inj setting.it is pressed on so will need a cummins tool.need to remove...
In response to the last couple messages,it is avail yet,just send me an email and can send pics and info,thanks.
If you are interested pm me with your email,can send pics and price.thanks
Yes it is an under lift.wheel lift with the grids,or frame or axle lift with the forks.can also sling tow off the bar if the axle of towed unit is...
Getting out of trucking and towing,and have a heavy under lift for sale.it is a quick tach unit.the only things you need on tractor is a slider...