Truck smokes when you start it up goes almost away when it gets hot but at idle you can see it. When driver pulls away and gets on it there isnt...
checked fuse everything was good power all the way into the cab told owner to drop it off at freightliner I was looking at it because he was a...
battey cable was shorting out. I use the cable that connects all the batteries and there was a break which wasnt supplying the ecm with the...
I checked the harness into the the sensor and only show 3volts (Im guessing its min 5) checked the connector on the frame and it only shows 3volts...
The owner was there checking fuses with the key on, Im thinking that code popped up when he pulled the ignition fuse and put it back in everything...
Turn key on everything comes on after 3-5 seconds ( NO ENG ) displayed on dash. You can try to start it and the starter clicks but every 4th time...
OK N14 Celect+ #3 cylinder dead White wire has 1.06 volts with key on Black wire 0 with key on When running White wire 0.1 or 0.0 volts...
Only misses when loaded and its worse when heavy if you bobtail its fine. Only between 1500-1600 then goes away.
Truck misses around 1500-1600 rpm on the high side when heavy. Once you pass 1600 goes back to normal and can drive at 1600 rpm no problem just...
1XP5B69X2WN449008
No head lights No marker lights Stops and turn signals work Plus I have 3 of these (94-97-98) so I would be good to have a good diagram.
Truck will be here tomorrow Ill start looking into the wiring only thing not changed was power to ecm, ecm has been changed too.
PID-108 Barometric Pressure I changed to new sensor yesterday 203.00 for sensor and harness. This didnt fix the issue. The sensor was located at...
Found 2 loose fittings in secondary tank and gov was sticking. So it would build up to 120 purge and start leaking down to 90 and would take for...
Looking for a tandum suspension for a dry van in the chicago area. Can be spring or air bag doesnt matter.
Im looking for a (wabash preferable) suspension air or spring to go on a 53 Wabash plate trailer. Anyone out there have one for sale?
I have a Kenworth T600 builds 120 lbs purges then starts to drop pressure. This is while the truck is sitting, I turn the truck off and I cant...
Looking for a 3406 Counter bore tool anyone out there have one for sale? Or for rent in the Chicago area (Aurora)
I think this is 40 pin looking for a wiring diagram so I can check ground and wiring harness to injectors. Use to have one but cant locate it.
