You could do it your self. You need a swr meter and a jumper. It's not very difficult and there's several videos on line thatshow you how.
I'm not real sure but maybe someone here can elaborate. From what I know, all the metal in your vehicle needs to be connected. Many times the bed...
20 or 19 just seems like splitting hairs but thanks for your input.
I got this 25 The other day that i started working on. The volume was very scratchy so I removed the knob to clean it out. I used a 3/8 deep...
For all following this thread I have a new update. I got my new antenna in and got it installed. I Don't know why I was worried about 5ft being...
In case anyone has any similar problems, I fixed it. I used a mosfet irf 520 kit and installed it. Apparently the final was bad. I adjusted the...
I had a Cobra 25 NW given to me the other day free of charge so of course I accepted. The thing received ok but had an obvious blown meter light....
Is everything tight (mount, antenna, stud, coax, ground)? I had decent swr then re located the antenna. Swr was good the first day then my...
Fire what it's worth, I had several radios I bought in the early to late 90's. I joined the army in 2000 and packed it all up till a few weeks...
Well, I got it all mounted up with the aluminum tool box. I went with mounting it to the driver's side of the toolbox close to the cab. I used...
Has anyone else had this experience? I haven't mounted the tool box yet but will this week. It's a diamond plate, aluminum I think, so no paint on...
Got it all figured out. Switched out the board with new one and it fired right up. I didn't re solder, just switched over the wiring. Hope this...
It has about 7 or 8 wires to solder (3grnd to pin 1, 1 hot wire, 2 to the TX pin#3 I think, 1 to the un soldered audio wire, and 1 to the audio...
I'll be back through there in a few days. If you so catch him on the radio, tell him to quit leaving them turds on the floor.
Thanks for the reply. I'll get to work on this later in the week.
I looked around that place and didn't see him or his shop. I did find a petrified turd at the pilot in the 3rd stall where someone missed the...
Very helpful, thank you. I did end up using one of these cans and is working fine.
I'm here now and don't hear nothing.
Thanks for the reply but I already had that and didn't understand what the hell I was looking at . I thought it was for an echo master echo box...
Does anyone know the wiring for this mic? I have one that was set up for my RCI 2950 but the plug got ripped off. I re connected pins 1-4 (braid,...
