Lol sorry I mean inside ecm itself If anyone has a diagram of ecm or a picture of chip that controls Jake's
Anyone got a diagram or picture of what ddec iv Jake controller looks like?
What would you recommend? Some one said to look in to gt4202 it's a 75m with 1.15 wastagate. Someone also mentioned 78m with a 1.15 ar and said...
S60 12.7
Yes Jakes have been rebuilt and new solenoids unfortunately going to bigger exducer losses that back pressure that 1.15 could build. Where 1.15...
Lol maybe I don't think making hp would be a problem as much as egt and possibly overspending to much pressure on the shaft risk of breaking it?I...
Will be hanging around CO running over Loveland,vail,wolf creek,monarch etc anywhere from 5k ft to 12k altitude. If Jake's and spool are greatly...
Has anyone tried s475 with 1.15ar ? How was the spool and egt? I am building another truck that will only run mountains. Looking for quicker spool...
Update went out to drain fuel out of devco took cap of and it sucked fuel back to tanks. I new right then it was bad check valve. Took it off it...
Yes I did figure it out it was bad overhead guy set my injectors height to 81m while I needed 82.1m what happened eventually my rocker arm for one...
Check valve on the back of the head is brand new two weeks old. This started happening last year was thinking of draining my devco and check it's...
Every time I park the truck in my driveway which has incline truck has hard start problem. Even in summer it will crank for few sec but on flat...
Engine is 2002 ddec iv quick update water temp gauge also doesn't show anything. I have traced ground in the harness where all sensors share...
I think so too I will trace it down and see what I can find
Yes both started at the same time and It does run if I unplug it. Wonder what I should start looking at harness? Grounds?
Series 60 12.7 hooked up laptop shows high voltage on boost sensor and shows no oil pressure trucks shuts down. Hooked up manual gauge shows 60...
FP 23532333 is the number for the kit and I bought on eBay But this kit didn't include graphite washers for injectors which sucked I had to order...
Looks like they definitely did some upgrading here is old s60 gasket vs new one I ordered
That's interesting I will check the gasket I ordered but one thing that came in different was exhaust manifold gaskets. Usually they are just thin...
Yes after 2002 they call for 220lbs before 2002 it's between 185lbs to 210lbs . But I am curious if torquing to 220 on older engines have any...