I worked for a Ruan terminal for almost 9yrs the 1st 4yrs where alright the last 5 it progressively got worse. Had 6 tms in that time 3 regional...
The best part with what I've been doing is I start the truck pull out of the driveway drive 2 miles down the rd and I'm at the elevator. That...
I'm currently running at roughly 4.11 a loaded mile that is what it works out to at .26 a bushel at around 950-960 bushels per load. This is...
My father in law just turned 65 today and plans at least another 10 years hauling steel on a flat with a side kit. Out works most younger guys...
I was told they go by the gvw doesn't matter what it's registered as. That came from a MN dot cop. Also my understanding is that you do need a...
The cadac system doesn't require an ecm but they've been obsolete for years. Where I use to work they had them in the late eights until 2000 and...
I'm awaiting the news on this too. I run an 88 mack which has a cable running the tach and the speedometer so no tapping into sensors.
I do all my own work except major stuff. I don't have the means to pull a trans I could mange an in frame have the tools and know how. But I...
I'm a bit different than most. I'm leased on to my father in law currently pulling his trailer but operate as my own company working directly with...
Company I use to work for switched to a full synthetic after running a blend for years when most of the trucks had around 350 - 400k on them. 07...
The best way I've found is to cut the head off (the rounded part not the threaded looking part) with a torch or grinder then take a good air...
If I remember right its been a couple years ago since had one apart. You have to take the door off and there should be some screws holding the...
I've had them crack on company units the tube and the part the spins into the front cover not too hard to change. So I'd check that before just...
That was probably from greasing the s cam a little too much
Don't grease the pins/rollers that ride on the s cam all it does is collect dirt and cause wear. Change the anchor pins and never seize them also...
If you end up going for it. I'd try to stick local for awhile or with in limping distance. I did and it was a good thing had some rear...
I'm running an 88 superliner but those are a little easier to find parts for since a lot is shared with an R model and an MH which is a cab over....
I would try to bleed it before doing anything. Ie cycle it a couple times if that doesn't help it could be the pre filter but most likely it's...
I pay cash. My father in law does too. We only go to certain stations avoid pilots or anyone associated with pilot. Our old trucks do not like...
I bought my truck from its original owner the company bought it new in 88 looked to be well maintained was not exactly what I wanted but will work...