All that has been done, the problem is, it blows cold at idle. Once you get up to speed it stops blowing cold, return to idle and gets cold again....
The evaporator was replaced along with the apads the gauges at idle are normal. the only parts not replaced is the condenser and compressor
Got an issue with the a/c. Blows cold at idle while driving after about 10 min it starts blowing warm. About 1 min after stopping at idle it gets...
Thanks for the info. The dealer I have been using are dumber than a box of rocks, they said it can't be done
I have a 2019 LT and the digital axle load is off appr. 2100 lbs. Can this be calibrated ?
heavyd, it seems that the manual reset had not been set up. got to take it to the dealer to get it done. thanks again for the help
Thanks, I'll give it a try Monday when I get back in the truck
got a 2019 LT with the eaton ultrashift 13 speed. The GI warning came on, I checked it out and greased the the cross shaft and release bearing....
That was one of the first things I did, thanks for the response.
That makes more sense than everything else I've tried, I'll let you know how that works out.
It's 3 red blinks. But as stated before, if you leave the fan over ride on there are no faults and the A/C works fine. Leave it off and when you...
Tried that, all the wires check out, the clutch and compressor have been replaced. Everything works until you slow down or stop, the engine fan...
When the a/c is on and blowing cold the engine fan won't cycle when stopped or at low speed. The APADS detects a fault and shuts the compressor...
Great news, I found the problem. The other day the truck wouldn't start. The Cat Messenger was showing "NO DATA LINK CONNECTION". I went straight...
That was the first place I checked. The last time I had it in the cat shop they recommended that the whole harness be replaced, It is old and...
Thanks for the info. I was wondering how I was going to figure out which pin is which.
Thanks for the idea's. I've been dealing with this for about 4 years and nobody including cat could help me figure this out. I'll let you know if...
The belt is tight, replaced the tensioner hoping that was the problem. replaced the alternator twice to no avail. all the cables were ohm'ed and...
I've got an 07, 9900i with the c-15 acert with a voltage problem that I have not seen in any of the threads. The truck starts and runs fine, the...
