I have a 2002 Freightliner Century with a Cummins N14. I am getting a dash error code for short in the outside air temp sensor. Can anyone tell...
Here is the answer. The tail lights were a broken wire in the harness. Easy find and fix. The engine information center going dim and the truck...
Haven't started the repair yet. Everyone including myself all have plans for Easter Sunday. The reason for the turn signal switch is that it is...
Alright everyone, here is a brain teaser for you electrical guys. Here is what I have going on. Have a 2002 Freightliner Century with a Cummins...
I would say you have a bad oil level sensor also. Check the wiring and plug at the sensor for corrosion also.
Ditto what everyone else said. Great little engine with decent fuel mileage. Mine is set at 440 or 445 from thr factory if I remember correctly.....
Doug, Thanks for he offer, but we do almost all of our own engine work and rebuilds. Wee have extra heads for them, oil coolers and pumps etc....
Stroll, Going to swap 5 and 6 injectors tomorrow and see if the problem follows. Also Cummins Quik Serve said to seat the injectors 4 times to...
Stroll, Turned out to be the number 5 injector. I just replaced it with a brand new one bought from Cummins. Unplug it and the knock goes away....
Hey everyone. Here is my dilemma. I had to replace my N14 because the driver ran it low on oil. Burned 4, 5 and 6 road bearings and a couple of...
Thanks everyone. That's what it was. Swapped old ECM and everything was fine. Well almost fine, number 5 injector is bad, but just about there.
Hey everyone, having some issues and hoping someone can help a bit. we did a N14 engine swap. Other engine lost the rear bearings. Installed used...
Josh, No worries, we all here to help each other !
I would be looking at the clutch very closely if it is froze. If you broke some springs inside the pressure plate or bad throw out bearing could...
I cannot remember where, but I have seen adjustable torque arms, where they are threaded king of like a tied rod. You can also buy the poly...
Cory, I added an extra zero in front , thanks for the correction, my mechanic was freaking this morning..lol. I made the corrections above.
Okay, Cory was mice enough to answer a PM for me , so I thought I would post the answer for everyone else. The road and main bearing clearances...
You most likely have a bad ground. I have also seen corrosion in connections for the trailer lights and turn signal lights back feed from...
My bad everyone. You are correct there is no fuel shut off solenoid on the 3406E. Was thinking of the "B" model thanks for correction.
Hey everyone. Got my N14 finally tore down. Ready to turn over the engine tomorrow to remove the crank. I know on the mains the oil gap should be...