It will turn like a 379 short hood, it's a little shorter than a long hood 379 but turning radius doesn't seem to be much different I don't think.
Honestly we don't see to many problems with them, no more than most stuff. Egr related problems mostly. Fuel pumps as well the gear driven one but...
What year? They have made isx 450 for 15 plus years now
On the older of the two issues we have tried with a speedy sleeve and also without, we have tried installing it flush as well as deeper in the...
That's not it, it is most definitely the front main seal without a doubt
Run out is good and it's from the seal where it contacts the crank. Gonna really have to dissasemble one and see what's up
Main bearings are new in both trucks. One has a new balancer and one does not so will try the new balancer. Have tried with speedy sleeve and without
Yes
Yes and both are good, one engine has 20k miles on a new out of frame.
I have two trucks I have replaced front main seals on with n14 and the very next day they leak again. We have done both trucks three times with...
Absolutely. We are doing a head on one of mine because it cracked at 818k and it runs 60k a year. But we do our own work so it's a little...
They are all brand new cat rods, new Pistons, new liners, reman block and crank. New head and all new oilers, so it is not an oiler. It's been the...
We put a different block in it this last time. We also cleaned and checked everything and it still did it. I am thinking it has to be the tune or...
We replaced it with a new one the second go round, we replaced all of them and checked them each and every time we have had it apart.
Could the tune have something wrong with it causing just one cylinder to get hot like overfueling or something?
It has a very large charge air cooler now but the coolant hose idea is a good one. We are also going to tune it down a little to try and keep it...
No it is not acert turbos but two turbos none the less. It was running with this exact set up for a couple hundred thousand before it cracked the...
Just noticed the skirt is broken right above the wrist pin and right below it as well
Yes, did the Same thing with old block and crank and doing the same thing with new block and crank, same noise and same cylinder. Did it with old...
And it just happens instantly, everything seems fine then pow tons of blowby and white smoke.