opening pressure is 18 psi at .039 rod movement, Done with air pressure regulator and dial indicator.
You might want to pull the front elbow off the oil cooler and check for debris plugging the tubes, all coolant must pass through the oil cooler to...
Spec Number 2T5003 Arrangement Number 1023537
FL Static/FT Static Fuel Settings in 0.276 / 0.276 Dynamic A/F control Set in 0.094 Fuel Valve Part Number Unit Injector Part...
Good to hear its running right, Lets leave the test ecm on for a week and make sure it is fixed. I have more ecm's, we can install a used one...
Left you a message on the number posted....
PM sent,
Sounds like you have gotten in to a mess, I hope you tech is pulling the liners for that failed head gasket or you will be in the same position...
If you have a 6NZ file in it then there should be no boost derate?
There are a few different injectors for the 5ek, you need to order by serial number or pull the valve covers and check the part number of the...
check under the passenger side floor and by the drier, you will find low and high connections, that is a switch connection you are looking at.
This engine has a history, crankshaft was replaced, I would be going after the cylinder cut out results before looking at the actuator results. I...
B class has turbo size limit and oem intercooler rules, that is the hardest part of making the hp for that class. Lack of air.....pm me if you...
Have seen that with 4 engines last year and one was stock. These failed under 1000 kms after overhaul. I would replace the liner pack and run it....
The difference is high mount or mid mount of the high pressure turbo.
Check the rocker shafts, are they installed with the flat side up? Seen them installed upside down causing lack of oil supply to jake due to...
Set the lash to .035, that will help. Jakes web listing says .037 but too loose will make the jake weaker.
What did you set them to? Lash has a large affect on holding power.
I keep them in stock, have Lipe 1 set at stock, 5000 and 6000 plate loads.
Chains are not allowed in the pulls up here. http://www.ottpa.net/ruleshwy.html