J1708 comm adapter will read it, the 9 pin round connector, doesn't use the OBD2 for engine. You can also turn cruise off and hold either the set...
I did on my truck, it can be a hassle with paperwork, I ended up refinancing with different bank after year and interest rate was lower, the...
Might recheck injector adjustment, if set wrong they can cause excessive black smoke. Is there a restrictor gauge or boost gauge to see if...
Just go to truck shop and ask for some 8 bolt shim gaskets, you'll have to try different combinations to get right setup in gears. K-2402 is...
Dump truck would need cooler more so than otr, lower gears and pulling heavy is where you tend to build heat. Other than that I havent seen to...
1in fill line is industry standard, I've never seen 1.5 I'd on any truck. A farm supply store will usually have a barb fitting to work. Spray...
After I put on a gear reduction starter, it sometimes fire right off, next time you may crank it few seconds but it always starts. Second one...
That's the line that fills the engine with coolant, it should be a standard 1in water line. The fittings should be, 1in or 3/4in pipe thread by...
I has similiar issue on c13, every time I put a load on it, it would shudder, like a misfire. Ran injector test multiple times(single and mutiple)...
On cutting length, either cage or uncaged both and just cut the same length. It should get you close enough to work fine. Running nut past where...
Usually the rears are what wear, I would say buy new rear mount, price isnt much different than bushing. Atleast for my T800 it wasnt much. I use...
Most times I run into that is high pressure switch connector. Sounds like you already changed the costly stuff.
What was previous life of truck, could either have a pto mode switch, where it will auto go to higher rpm. Other cause would be if voltage is...
Sounds like you may have already fixed your truck. But my F450 I did a Reyco rear suspension, it cost around 3500 and is build more like a...
All your truck throw out bearings mount to the clutch, not a separate bearing like a car. The are a regular ball bearing enclosed. I have seen...
Just my 2 cents. I work alot on mixer trucks, similiar application and have noticed anything over 1700ft lbs on clutch seems to be too jerky and...
I've had a similiar issue on reman injectors, more money but I would only go Cat parts on it, have had other remains miss right away. Another...
Could look for the dt530, little bigger, try and find fire truck version, they had highest rating from international. If electronic may have...
I did similiar swap except went 20k. Easiest is look at junkyards for one, most axles will interchange, you will need to buy heavier springs. I...
I do mechanic work and seen quit a few allisons. The 2500 is a lighter duty compared to 3000 or 3500. They are good for road use but seem to wear...
