Use the power and grounds from the alternator and hook up to the clutch. At least then you know your clutch I's ok. Then turn ac on the check...
HC loading? I'd like to see this info. I've never heard of it. Auto elevate will not stop DOC face plugging.
For the wiper you need to measure voltage at pin d on the wiper motor. Turn wipers to high with key on. You should get battery voltage. With the...
You WILL destroy your ATD if you idle too much. And it won't be covered by warranty. I
Oh nvm the stalk switch. I missed the part where they move slightly. Would need your Vin to get wire numbers so you can check your wiring. If your...
Vin? You probably have a corroded wire causing the dim light. The wipers I would suspect the stalk switch.
Pull the four torx screws on the out side of the firewall. The reservoir is attached tp the pedal assembly. Once you remove the four screws you...
Check for fuel leaks on the engine. Make sure to check the fittings on the l/s rear of the head. The dealer should have pressure tested the...
I would think that was the problem. Post again if It starts and I can maybe find some troubleshooting or a schematic.
You can also pull the reverse connector off the transmission. If they stay off with it unplugged then the reverse switch is at fault.
If you check the tail light connector(should be a 5 pin plug) make sure that pin A (red wire circuit 120B) is going to the reverse light and pin...
I'd the headlights are off will the reverse lights go out?
Last 6 of the Vin?
Thanks for contributing to climate change! my kids thank you!
Yes it's normal.
Make sure all your grounds are clean and tight. Make sure the wiring has continuity and then use a headlight and put power through the wire.
Could just be programming. Has it just started?
What are you running? DD15? With a Dt12?
Relay and abs valves.