I have 2007 9400I with Cat the guages Engine Oil temp. Transmission temp guages Quit working the Voltage guage when you accelerate goes backward...
I have 2007 9400I International flash code 77 F:005 Sid007 need to know how test for that bendix system
I have a similar issue oil pressure guage goes to 6 and my fuel guage is bouncing around and no flash code
Type of work I do it hit pot hole broke rod everything it’s hitting stop the reason I started looking at ride height
How do I adjust ride height on 2007 9400I International?
No they donot park properly. I have power on the red wire 82c at wiper motor and not power to other wires at the motor. At 82E firewall connector...
I have 2007 9400I wipers works on high only I can hear low and high relays kick in but low and intermittent does not work
F1B has now power on either side of breaker post
AC control has power to it but the freeze Switch has no power to either leg air con relay when I unplug doesn’t click the ac control relay does...
Thank you for all help got buy u supper sometime
No sir
2007 9400I AC quit blowing 40 degree air 2 hours later no cold air all fans blows Ihave replace Compressor Condenser Evaporator Expansion valve...
I knew u said it was a message center I have beep in dash no fault code no light U hit bump it beeps but not fault now the speed speedometer when...
I know this is same old thread But the message center in dash has this I would like to know what it means 128:F 14 PID084_A 2007 9400I C15 Cat
No engine off key off fine last night i cleaned all grounds again turn key on I call it popping static I have a power filter in line to I have a...
Static is what I meant
Also wouldn’t you have to run engine to pick up engine ststidc
I changed everything in battery box cleaned every ground outside the truck. I ran Cb to batter then changed ground to chassis the engine does not...
i have 2007 9400I International key on engine not running popping static in Cb Voltage falls down to 12.5 on acceleration Noise gets louder but...
I know this is a old post I have posted on before I have notice with engine off in the on position I have poping sound I have checked every ground...