Anyone have one of these seats? Thoughts compared to Bose Ride? I’m assuming similar technology. Also any difference in the Grammer Kingman...
until you posted, I’d forgotten about this thread. I too would love an update
You’ll need a SHV permit to possibly even get 73,280. You’ll need to measure your inner bridge law between axles 2 & 5. That’ll tell you what you...
Got my dream truck already. 1999 PETE 379 EXHD N14 Celect Plus 525HP 3.55’s 13 speed 285” WB. My baby. However for a backup I would love a RW713...
Yes thank you. Was just trying to make the point between two engines and experience that was the same for comparison. That’s all
Also remember, labor costs will most likely be more than the parts themselves. Ex: My injectors were $3k roughly. To have that done in a shop...
how much would you have left if you bought a $50k truck for maintenance? Pay now or pay later. Know what you got or take a chance. Choices only...
IMO. And it’s just that, my opinion. Find a cheap truck with good bones and fix it up. There are 2 ways to go about it and I have two friends...
Inframe $7000 parts only for my engine. Clutch and tranny, oil and possibly bell housing $6000’ish parts only Eaton reman CAC $1500’ish Radiator...
You can check PAI. They make one also. $400-$500 range. I’m in same boat. Trying to decide. Can’t justify the $1500 for full tilt running...
You’re right. If you have the tools and knowledge. A lot of guys don’t have the tools it would take to yank an engine out of frame. Heck a lot of...
A friends truck went down the same time mine did. I did inframe myself, he went to a shop. I started Monday morning at 8am and worked 8-5 on it...
Well got ECM fixed at SIA still had injector issues. Pulled out all 6 aftermarket injectors returned and got refund, purchased 6 Cummins injectors...
I have been satisfied with Midwest as well, but a lot of guys around here have been having trouble after 6months to 18 months with ECM’s that were...
For informational purposes to anyone that reads this. I went to SIA in Tilden, IL for ECM work. Needed it ASAP. They are 2 hour drive from me....
Little update. Truck being put on CPU today. Thinking that running any injectors other than Cummins might be the problem. Getting a lot of...
I didn’t know that. I’ll check into it. Thanks for the info
Just so everyone knows, I tried a set of injectors remanned by Ambac International out of South Carolina I believe. 2 year warranty supposedly...
Is SmokinCat still on here? Haven’t seen him around on here but then again I’ve been pretty absent myself.
Where is everyone having the best luck getting ECM From? Midwest ECM IN Colorado? SIA in Illinois? Diesel ECM exchange in NC? Cummins said it’s...